Raw materials for Dairy cow feeds
The problems of mycotoxins in dairy cattle rations
Certain kinds of molds in feedstuffs are a periodic problem to livestock producers, although many molds are quite beneficial to the well-being of man. Penicillin, soya sauce, and roquefort cheese are examples of products derived from beneficial molds. Therefore, all molds must not be considered undesirable, but rather should be judged on the basis of the individual mold and its habitat.
Mycotoxins are the poisonous substances that can be produced by certain molds under certain conditions. The term "mycotoxin" is derived from myco meaning fungi and toxin meaning toxicant of biological origin. Mycotoxins are secondary substances or metabolites produced by a wide range of fungi, principally molds. There are over 100 species of molds that produce mycotoxins. Most mycotoxins of importance in Florida agriculture are produced by species in the genera Aspergillus, and Fusarium. Mycotoxin-induced diseases in animals are called "mycotoxicoses," whereas diseases caused by fungi are termed "mycoses." Until about 1960, the problem of concern was centered mainly on poisoning of animals and associated economic loss. More recently, the issue is food safety due to the food-chain transfer of residues. Also, advancements in analytical procedures have provided a means for identifying and quantitating mycotoxins and their metabolites in meat, dairy, and poultry products.
The mycotoxins of greatest concern to dairymen are aflatoxin B 1 and B 2 . Two others that are being studied and frequently appear to be of concern to ruminant animals are zearalenone (F-2 toxin) and deoxynivalenol (vomitoxin). The effects of zearalenone on ruminant animals is still somewhat controversial. Some reproductive problems in ruminant animals have been blamed on the presence of zearalenone even though such reports have not been experimentally documented. The two mycotoxins that will be discussed in this paper are aflatoxins and vomitoxin.
Susceptibility of Feedstuffs   
The   susceptibility of different feedstuffs to mold infection is  directly   related to their adequacy as substrates. The seed or kernel,  because of   its richness in carbohydrates, is a frequently targeted  plant part.   However, other species of molds utilize cellulose and  therefore prefer   the more fibrous parts of the plant. Even so,  aflatoxins grow primarily   on grains such as corn. Many factors that  enhance mycotoxin production   do so by increasing the availability of  substrate to the fungus.   Aspergillus flavus and Aspergillus  parasiticus produce four major   toxins: B 1 , B 2 , G 1 , G 2   . These  were named according to their fluorescence properties under   shortwave  ultraviolet light on thin-layer chromatographic plates; B 1 and B 2  fluoresce blue, whereas G 1 and G 2 fluoresce green. Metabolites of  toxicological significance include: aflatoxin B 1 (AFB 1) AFB 2 and AFM 1    . On soybeans, only negligible strains concentrations of AFB 1 are    produced by both species. Aspergillus species is capable of colonizing    most of the important grain crops including corn, small grains,  peanuts,   cottonseed, and most nut crops. 
Damage to the seed coat   (pericarp) of corn induced by insects,  drought, hail, frost, or   mechanical harvesting favors fungal invasion.  Moreover, insects can also   serve as carriers of fungal spores. The  three crops with high potential   for invasion by Aspergillus species  during growth, harvest,   transportation, or storage are corn, peanuts  and cottonseed.   Colonization of soybeans and small grains generally  occurs in storage. 
The   occurrence of preharvest mycotoxins in grain and other  feedstuffs from   different areas is primarily a function of climate.  Toxigenic fungi that   produce aflatoxins thrive in the warm, humid  environments that exist in   the southern United States. Other  mycotoxins, such as the Fusarium   species that produce trichothecenes  and zearalenone, require both warm   and cool temperatures. 
Aflatoxin-producing strains of   Aspergillus are distributed worldwide  in soil and air. When   environmental conditions are favorable, and  substrate (feed or seed) is   accessible as a nutrient source,  colonization and mold growth can easily   occur. In general, mold growth  and aflatoxin formation require a   moisture content greater than 14  percent, a temperature of at least   77ºF, and some degree of aeration. 
Corn . The elevated content of aflatoxins found in  corn in any given year is   usually the result of increased invasion by  molds prior to harvest.   Contributing factors include drought, insect  damage, and kernels with   damaged seed coats. Other contributing  factors include corn harvested   late, competition from weeds, and  inadequate fertilization. Corn placed   in storage inadequately dried  will probably be invaded by molds. 
Cottonseed . Aflatoxins found in cottonseed are  usually due to some sort of field   problem such as heavy rainfalls  during late July and August. Again,   Aspergillus flavus penetrates the  seed through damaged areas such as   exit holes of the pink bollworm.  Cotton harvested late due to rainfall   and before the moisture has  evaporated is subject to aflatoxin   contamination. 
Peanuts . Peanuts can be   colonized by Aspergillus  species in the ground before digging, during   curing and drying in  windrows or stacks, and in storage. Before digging,   invasion has been  attributed to drought-induced stress, damaged pods,   or over maturity.  After digging, a moisture content of 14 percent to 30   percent is  conducive to mold invasion and subsequent aflatoxin   formation, but is  prevented when the moisture is very high. When peanuts   are being  cured, retardation of drying by rainfall or humid weather   conditions  usually results in some degree of aflatoxin production. 
Metabolism of Aflatoxins 
Aflatoxins   are easily absorbed from the gastrointestinal tract, are  extensively   metabolized, and the majority of the dose is eliminated  from the body in   a relatively short period. The metabolic fate and  distribution of   aflatoxins in livestock is of concern for two reasons:  (1) metabolism accounts for much of the extreme toxicity and carcinogenicity of aflatoxins, and (2)  distribution of the metabolites to various body locations of food    animals can impart hazardous residues to products used as food for man. 
Aflatoxin B 1 in the feed of an animal is converted in part to a  hydroxylated compound, aflatoxin M 1 , which appears in the milk of  lactating cows. Studies reveal that relatively small amounts of AFM 1  appear in milk within a few hours after aflatoxin AFB 1 containing feed  is consumed. The level of AFM 1 in milk disappears within a few milkings  after the source of AFB 1 is removed from the diet. 
The concentration of AFM 1 in milk increases proportionally with the  amount of AFB 1   , in the diet of the lactating dairy cow. When  ingestion is continuous,   milk concentrations will increase until an  equilibrium with intake is   established. The conversion rate of AFB 1  to AFM 1   varies some with source of contamination. Recent studies  indicate that a   greater percentage of AFB 1 is secreted in milk as AFM  1 than was earlier reported. The data shows that the reported ratio of  300:1 probably underestimates the actual transfer of AFB 1 to AFM 1   .  The mean ratio as reported in more current studies varies from about    58:1 to 75:1, depending on the commodity studied and the level of milk    production. The average transfer in Table 1 for cottonseed meal is 1.71    percent (58:1) and 1.33 percent for corn (75:1). The transfer varies    some depending on level of milk production. 
Table 1. Effect of Source of AFB1 contamination on levels in milk.
| 
      Treatment  | 
     
      ppb (ug/kg)  | 
     
      Milk prod.  | 
     
      AFB 1   | 
     
      MY (lb)  | 
     
      AFB 1   | 
     
      AFB 1  | 
 
| Cottonseed meal | 
      44  | 
     
      High  | 
     
      966  | 
     
      66.9  | 
     
      0.28  | 
     
      1.95 (51:1)  | 
 
| Corn | 
      49  | 
     
      High  | 
     
      1116  | 
     
      68.6  | 
     
      0.23  | 
     
      1.42 (70:1)  | 
 
ug/kg = Micrograms/kilograms1Frobish et al. J. of Food Protection, Vol. 49, Oct 86.
The present actionable FDA guidelines for AFM 1   in milk is 0.5  ppb and for AFB 1 in feed is 20 ppb. According to the   average transfer  value of 66:1 obtained from Table 1 [(58 + 75)÷2], a   concentration of  20 ppb AFB 1 in feed would result, on average, of 0.3 ppb AFM 1   in  milk (20÷66) which is below the legal maximum of 0.5 ppb but still   can  result in damage to the animals (see following section Effects of    Toxicity from Aflatoxin and Vomitoxin). A concentration of 33 ppb AFB 1  in feed would result, on average, in an AFM 1   concentration in milk  near 0.5 ppb (33÷66) thus making the milk   illegal. These values are  simply good guidelines, not precise numbers.   The amount of aflatoxins  transferred from the feed to the milk will be   influenced by the type  of feed source containing the aflatoxin (corn,   cottonseeds, or  peanuts) and by the amount of milk produced by the cows   fed the  contaminated feedstuffs. 
Stability of Aflatoxins 
Aflatoxins and their metabolites are highly stable during normal milk  processing procedures. In one study, the AFM 1   concentration in milk  was not reduced by either vat pasteurization or   high temperature short  time pasteurization. After 17 days of storage at   39 o F the  concentration of AFM 1 in pasteurized milk was the same as the aflatoxin  concentration in raw milk. 
Identification and Guidelines 
The   blacklight, 365 nanometers, can be utilized to screen corn prior  to   purchase, sale, or use for feed. Generally, one "greenish-yellow    glowing" kernel per pound represents about 20 ppb; 10 positive kernels    per pound, about 200 ppb. 
False positives or negatives occur   with this screening method in  about 30 percent of the samples examined.   Therefore, assay or testing  by official methods should be used to   accurately identify the level of  aflatoxin indicated by the use of the   blacklight. This requires  submitting a good representative sample (about   10 lbs) to laboratories  such as the State Department of Agriculture and   Consumer Services  laboratory located in Tallahassee. The laboratory   should be qualified  for analyzing for mycotoxins. 
Present FDA   regulations for the feeding of aflatoxin-contaminated  rations to dairy   cattle suggest a maximum allowable level of AFB 1 in  the total ration of 20 ppb, which could possibly result in a level of  0.27 ppb AFM 1 in milk (75:1). The present actionable guidelines for AFM  1 in milk is 0.5 ppb. 
Effects of Toxicity From Aflatoxin and Vomitoxin 
Aflatoxins . Early indications of aflatoxin toxicity  include reduction in feed   intake followed by weight loss or decreased  rate of gain. Also, there is   usually a decrease in feed efficiency,  increased susceptibility to   stress, and decreased reproductive  performance. Calves are more   susceptible than older animals. Chronic  aflatoxicosis is characterized   by unthriftiness; anorexia; a drying  and peeling of skin on the muzzle;   prolapse of the rectum; liver  damage; elevated levels of blood   constituents such as cholesterol,  bilirubin, and serum indicator   enzymes; and edema in the abdominal  cavity. Milk production may be   dramatically decreased in dairy cows  fed aflatoxin-contaminated feed.   Almost any level of  aflatoxin-contaminated feedstuff in the ration may   lead to some liver  damage, especially in young animals. 
Deoxynivalenol (Vomitoxin) . Deoxynivalenol is more  commonly called vomitoxin or "DON" in the field.   As the name implies,  vomiting and feed refusal are associated with the   consumption of  contaminated feeds, especially in swine and ducklings.   Vomitoxin is a  mold toxin produced by species of fusarial molds. It has   been  associated with reduced feed intake, unthriftiness, reduced weight    gains, and decreased performance. Other symptoms include diarrhea,    abortion, hemorrhage, hematological changes and nervous disturbances. 
The   U.S. Department of Agriculture has not established official DON    maximums and there are no federal regulations to control it. A  potential   hazard has been suggested at levels of 2 ppm in the feed.  Higher levels   have been reported. The presence of DON in a feedstuff  is considered a   possible marker for the potential presence of other  fusarium toxins. 
Management Considerations 
Good   management practices will help reduce the problem of mycotoxins  in   dairy rations. The first preventive measure is to purchase  ingredients   that are relatively free of mycotoxins. Beware of  feedstuffs that appear   suspicious. Store grains at moisture levels  less than 14 percent.   Commence a clean-up program around the feed mill  or feed troughs to   eliminate damp areas suitable to mold growth. Be  very cautious in the   purchasing of corn and/or peanut meal during  seasons when crops are   being harvested following a drought. 
Aflatoxin-contaminated   products must be excluded from the food  chain. Sources of contaminated   feedstuffs must and should be avoided  in feeding programs. There are   some alternative methods to salvage a  damaged product such as corn. Of   the available methods, ammonium  treatment appears to offer the best   alternative. The combination of  ammonia (0.6 percent to 4 percent),   heat, and moisture (10 percent to  20 percent) is particularly effective.   Decontamination is usually  accomplished by placing the product in a   sealed polyethylene bag.  Since ammonia is dangerous, contact an   experienced operator for  conducting the process. 
by Barney Harris, Jr. and Charles R. Staples - Institute of Food and Agricultural Sciences, University of Florida





















